Easy dog bowl riser or planter riser.

I made this riser from scratch so my Pit Mix could eat at a more comfortable height. It easily holds his bowl, which is about 180mm wide at its base. From the floor to the top of the bowl is approximately 254mm, and from the floor to the surface the bowl sits on is approximately 180mm. I designed the legs to flair out at an 8 degree angle, which is also the angle of his bowl, so it looks symmetrical. It has a half lap joint in the middle, and uses 2 dove tail joints to join the larger half to the smaller half of each of the 2 sections. I used a couple drops of CA glue to permanently join all 4 pieces. It prints on 2 plates at its current size.

Please note that I intentionally made the dove tail joints slightly different on each of the 2 legs as to prevent getting them confused and incorrectly assembling them.