wall / desk clock Goofy LED-translucent

I have made another Hueforge clock here. Maybe some of you also like this clock.
I could imagine that this watch would also be a very great gift for someone.

This time the dial is translucent, and also suitable for my new wall mount / table stand... here is the link: [https://makerworld.com/en/models/752579#profileId-686476](https://makerworld.com/en/models/752579#profileId-686476)

I created a version with 170 mm for the Wall/table and one for the Wall with 245 mm

If you would like to get others excited about these wall clocks, please share the link on social media.

Here you will only find the dials!
You can find the necessary accessories under the following links:

You can find suitable clock hands here:
[https://makerworld.com/en/models/603977#profileId-526590](https://makerworld.com/en/models/603977#profileId-526590)

You can find the coloured back panel and further wall bracket for the 245 mm version here:
[https://makerworld.com/en/models/603993#profileId-526611](https://makerworld.com/en/models/603993#profileId-526611)

You can find the coloured back and the table stand for your dial here:
[https://makerworld.com/en/models/600983#profileId-523239](https://makerworld.com/en/models/600983#profileId-523239)

Would you like to put the clock on the fridge? Then visit this link:
[https://makerworld.com/en/models/643115#profileId-569109](https://makerworld.com/en/models/643115#profileId-569109)

You can find an LED module for the dials here:
[https://makerworld.com/en/models/643259#profileId-569271](https://makerworld.com/en/models/643259#profileId-569271)

To minimize print time without compromising quality, I configured height range modifiers in my print profiles. So don't be surprised if the swap instructions don't match the data in the print profile

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Swap Instructions:
Start with Jade White
At layer #15 (1.28mm) swap to Black for the rest.

If you get the message with the floating regions when slicing... you can ignore this

Here you can find my other dials collected
[https://makerworld.com/en/collections/1715414](https://makerworld.com/en/collections/1715414)

Descrição