NEW AND IMPROVED VERSION AVAILABLE CLICK HERE!

A stackable OHUHU marker holder. These markers are 15ish mm in diameter. 
This design is based on my design for the Tooli art Markers and again a wish from my girlfriend for a more accessible storage for her markers.

I also have made a lid and slanted foot for this organizer and will upload those soon too. I will add links below when so.

Again I've made sure to try and keep filament and print time as low as I can with my knowledge. One tray should be around 80 grams.
These also have a little compartiment to hold a 4x1,5 mm magnet to keep it al a bit more toghether. But from my experience it is not needed and one should not stack too much in one pile.

It's made to be printed starting on its back.

It should not require support, but keep speeds within a reasonable setting.