Desk organizer remixed to work with the base from the superb gridfinity with pin system. They remain 100% compatible with normal gridfinity but can now click into the gridfinity with pin bases if you want a non magnet stronger fixed solution.

Each module in this project is 6U height

Modules

• EDC
  • Wallet / Cards Module
  • Phone Module
  • Catch-All Wave Module
• Writing
  • Pen / Pencil Module - Large
  • Pen / Pencil Module - Small
  • Pen + Compartment Module
  • Post-it Module
• Compartments
  • 2 - Compartment Module
  • 3 - Compartment Module
  • 8 + 1 - Compartment Module

• Accessories

  • SD Card / Micro SD Card Module
  • USB A Module - Large
  • USB A Module - Small

   

You probably also want to get some standard gridfinity with pin bins from here

[https://makerworld.com/en/models/440625?designId=440625#profileId-346318](https://makerworld.com/en/models/440625?designId=440625#profileId-346318)

If you want to use the gridfinity with pin system you will need one of the bases from One Maker Show:

[https://makerworld.com/en/models/440624#profileId-346300](https://makerworld.com/en/models/440624#profileId-346300)

Also worth checking out his collection of other compatible designs:

[https://makerworld.com/en/collections/1143270](https://makerworld.com/en/collections/1143270)

I have remixed this model here trimming the gridfinity with pin base from a previous remix of mine to make sure licence terms are complied with as that was remixed under a different licence (the licence on the original bins has now changed) but you should go check out the bins whilst you are getting the bases as you will definitely need some!