Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
NEW Retractable cable organizer with stop is out! 👉 Retractable Cable Organizer - With Stop
A simple retractable cable organizer that consists of only three parts! The spring allows the cable to be retracted, so your cable will always be wound correctly! No more manual winding!
- Both textile and rubber cable can be used. Maximum cable diameter is 4.5 mm! Maximum cable length is 1.2 m. (so far 🤫). Textile cables have lower friction and are therefore easier to wind.
- I recommend printing the spring from PETG, but PLA can also be used.
The model is designed for minimal supports. I recommend using my print profile!
Location of supports at the coil 👉Assembly instruction
Place the cable evenly in the coil and place the coil into the Cover. On the bottom floor of the coil, hold the cable as shown in the gif below.
Turn the spool in the direction marked on the top surface! When the cable is fully wound. Keep pushing the cable down!
Place the spring on the hexagonal shaft. The spring hook must be rotated 180°-270° from the groove in the coil. So that the spring is preloaded!
Retractable Cable Organizer
Publicado em 23 de out de 2024