Angle grinder key / wrench

This is a angle grinder key / wrench. I modelled it since my Ryobi angle grinder came without a wrench to change cutting disks.
It's a quick print, under 30 minutes and with 8 walls it is very durable and does it's job well!

Besides the printed part you need four M5x12 screws to make it work. Insert the screw right into the holes all the way down and you're good to go!

Note: The length of the screw doesn't need to be exactly 12, anything between 8-20 mm should work just fine since the part is 5mm thick. I have only tested this for my angle grinder which is a cordless Ryobi. The middle hole measures 22,5 mm and the screws are spaced in uniformly a 30,5 mm circle, the outer diameter of the handle is 42 mm and the total length of the wrench is 141 mm.

I hope you too found this model useful!

Descrição