Descrição
I created this model for my daughter's Halloween costume. She wanted a wand that was longer than I could print in a single piece. This three piece design is surprisingly sturdy when assembled.
I have created a few more variations of this wand. All parts are interchangeable.
For X1 and P1 printers, the wand shaft are printed vertically to improve finish and eliminate the need for supports. The shaft is 10mm diameter and 240mm tall. Print with door open or things will get a little inconsistent at the top of this tall, thin print.
For A1 printers the wand shaft has a small flat area on the side to increase surface area of the first layer. The shaft is printed horizontally with supports. The bed movement of the A1 printer will likely cause the print to fail when printing vertically. Please select the correct print profile for your printer.
