I present to you a manual textured turntable with a diameter of 250 mm for 3D scanning.
The model is based on the image of a turntable from 3DMakerPro.

If you are not interested in textures on the table, there is also a version without them.

Together with the stiffening ribs the table is only 3mm thick, keep this in mind if you are looking for a very rigid table.

To use it, you will need:
1. Bearing 6201, external diameter 32 mm, internal diameter 12 mm.
2. Some masking tape.
3. One or two rubber bands.

I specially made gaps in the place where the bearing is installed so that with the help of masking tape it would be possible to adjust the density of its fit and subsequently not suffer when dismantling it.