After my collapsing simple dagger was so popular, I decided to do a collapsing estoc sword. The design is inspired by Elden Ring.

There are two versions. One is print in place and single color. The other one is made of three parts: the handle, the pommel and the blades. You can print this multicolor like the one in the picture.

The red one was printed on an A1, the multicolored one on an X1C. I advise to not rotate the models since the rotation of the blades is crucial for a successful print.

If you swing them with too much force, the tip sometimes gets stuck. The easiest way to solve this is by pressing the tip against the ground and then gently tapping the back of the pommel till it snaps back inside.

If you have any problems with this print, feel free to reach out to me.