This item fixes a flag onto a flag-pole. It is designed to slide through a flag then onto a 6.0 mm diameter pole and then tightly grip the pole preventing the flag from flying off in the wind or when riding through low hanging branches.

Design considerations:

• Rounded sides to keep branches from dragging the fixture off of the pole
• A twist has been added to the slit where the flag is allowed through to increase drag which results in keeping the flag out from under the fixture
• The fixture hole has an inside diameter of 6.25mm which on my Bambu printer with a 4mm print head was snug enough to hold the flag tightly

Note: If your pole has a different diameter, just scale the fixture up or down accordingly, or remix your own :)

For installation, see the last three photos:

1. Slide the flag just above the bottom of the fixture through the slot
2. Fit the end of the pole into the open end of the flag
3. Push the fixture over the pole and pull the fixture down