Batman hueforge

Hello everyone! I leave you a story in this case of one of my favorite heroes Batman, I hope you like this type of templates. Oh, by the way, you can rescale the design but not alter the z axis. Thank you

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x133.33mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 2.5mm

Filaments Used:
PLA BambuLab Matte Charcoal
PLA BambuLab Matte Ash Gray
PLA smartfill blanco frio
This print uses 3 unique filaments

Swap Instructions:
Start with Charcoal
At layer #10 (0.88mm) swap to Ash Gray
At layer #20 (1.68mm) swap to blanco frio for the rest.

Descrição