Recently printout Deadpool and Wolverine masks and needed a stand. So I put this together.
You will need a 3/4 inch wood dowel cut to your preferred length.

Plaque - has a notch in it so it can be glued on the base at an angle. You can also glue it facing straight up on the base if you like. I paused the print for the color change on mine.
I did use supports on the notch in the plaque.

base-bottom.stl - This doesn't need to be printed unless you are gluing the eyes on like I did. It is only 2mm thick so adjust the Z height in your slicer if you need it thicker.

Print Settings

• Printer brand: Longer
• Printer: Longer LK5 Pro
• Rafts: No
• Supports: Yes
• Resolution: .2
• Infill:  10
• Filament brand: Esun
• Filament color: Ruby Red
• Filament material: PLA
• Notes: I printed everything but the plaque at .28 to save some time.
  Plaque was done at .2