Description

A kob that allows finger tightening of bolts. It comes in 2 halves, the lower half has the bolt pushed through and should be a snug fit for the hex bolt head (if a little loose then a drop of superglue will fix). It has a threaded top half which you then screw the cap onto making a neat fastening. The outside ofthe knob is knurled for better grip.

Printing

The attached profiles have a plate for each size, 5mm, 6mm and 8mm (the most comming sized bolts benefiting from knobs). The body prints with no supports but the cap will require supports. The print profile already is set up with supports for the cap and the settings should allow easy removal.

Note

Note that in the main profile, I have set up the interface layer for the supports to use PETG and this makes it far easier to remove the supports. If you do not have PETG or do not have an AMS unit, then use the print profile without the PETG interface layer.