Hello!

Simple and small acorn container for pills or other things.

Can allso be used as a surprise for children, you can put a toy inside!

This model is also scalable if you want a bigger container!

If youre doing this- make sure to turn on supports for the acorn top!!!!!

The lid just snaps on top, depending on filament brand you might need to pull hard the first time to get it a bit loose.

To open it more effectively, squeeze the walls of the container and then pull the lid off.

This print doesnt require any supports!

NOTES AFTER PRINTING:

The acorn top part will probably have a couple of loose strings in the middle. Don't worry about those, they are fine, I tested it 3 times and it worked perfectly on all 3 prints. Just remove the extra “strings” from the top part and youre good to go!

Print settings:

• 0.4mm nozzle
• 0.2mm layer height
• 2 walls
• 15% infill, gyroid
• PRINT INFILL FIRST THEN INNER/OUTER WALL (turn this option on in bambu slicer)
• add outer brim only for the acorn top

Filaments used were BambuLab Silk Bronze, Basic PLA Gray and Brown and Iridium Metal PLA

Happy printing!