Soldering cable / wire holder

Hi Makers!

I sometimes have to less helping fingers and so I created this simple, but very helpful soldering tool that can hold a variety of different wires or cables properly in place while you are welding them together or cutting them to the right length. (In this case it's recommended to print 2 or more)

There are fixtures for very thin cables down to 1mm up to thicker household cables of about 6-7mm, you just need to press them into place in the fitting location;-)

On the bottom side there are locations to glue anti-move pads or maybe other fixtures and implemented screw holes to tightly secure it to a table etc. Compared to other similar models available it is much bigger and can hold more cables at higher distance, resulting in a larger work area and improved heat dissipation.

The default material selected in the print profile is PETG, but you can also find a suitable PLA profile in the print profile section which has been tested too. Due to the bigger space the evoked heat won't affect the structure of the model in normal scenarios, but you easily may print it in a different material.

Feel free to scale it to your individual needs, as this way it can potentially hold even thinner or thicker wires.

I hope you enjoy my work and have fun and success using it!

Best regards

😃

Descrição