I needed a funnel to fill oil into my cars engines. So - simply go to a hardware shop and buy one, right? Boooooring!
Why buy something when you can make or even overengineer something?

This is a large speed funnel with six additional air channels to let the air out when you are filling the funnel. The small opening has an outer diameter of Ø38mm. It should match the oil filler port of many engines. Of course you can use this funnel for all other opportunities - in my case, I am just using it for my cars.

Print preparation:
Make sure that your print bed is clean and grease-free and use a quality brand high-speed filament. PLA is recommended but of course you can use PETG. Then you have to adjust my print profile because the profile is for PLA only.

Print settings:

This funnel can be printed on any Bambu printer, even on the small A1 Mini. Just use the 0.20mm Standard settings in the slicer. Support is not needed. You can cut the printing time by 30 minutes if you have an X1 / P1 because these have a significantly higher acceleration.

Assembly:
Nothing to do here, just start funneling.

If you want to support me you can leave a tip at ko-fi.com/blecheimer.

Disclaimer:
This work by blecheimer is licensed under a Standard Digital File License. It is for personal use only (e.g. printing, gifting, presenting, showing). All files and any prints of it must not be used commercially. Any form of charging money or collecting fees for this model is strictly forbidden.
Sharing, sub-licensing, selling, renting, hosting, transferring, distributing, adaptation or derivats in any form or format is prohibited. This includes remixes. Copying or hosting this model to other digital websites, online stores or cloud services in general is not allowed.