Thanks to CRMoriarty for the original design.

To be clear the files included in my remix are the same as the original design BUT I have also added the files I made for the diffuser covers.

I printed CR\Moriarty's original design and glued the pieces together then screw mounted them in my enclosure. I then ran the LED's (also using hot glue to keep them up the adhesive on the back of the strip wasn't enough so they needed glue tacks) and then the wiring down the side of the table to the power, which is wired directly into my printer through a buck convertor.

1 Corner piece for each the moutn and diffuser has a small cutout for the wiring to run out of.

Using transparent PTEG I printed the diffuser covers which will snap onto the original track without need of adhesive. They are tension mounted so they are tight but they will go on and they hook over the small inside lip on the inside of the track.

I needed diffusers because the light is above eye level near my desk and the unfiltered LEDs hurt my eyes. If your setup is below eye level you may not need these.