This is a springy flower collection. My wife liked my springy flower so I kept going with it.

Do not scale down or the threads will not work! Print at a fine layer height such as .12mm.
An outer brim is required on the cactus and cactus flower, flower stems, the daisy cap and tulip.

The springy dirt snaps into the flower pot. Then pick your stem and flower (or the cactus) and screw it into the dirt.

The models shown were printed with ABS using a .12mm resolution.

UPDATE: A crocus flower is available here: [https://makerworld.com/en/models/2867480-crocus-flower-springy-flower-collection](https://makerworld.com/en/models/2867480-crocus-flower-springy-flower-collection)

UPDATE: A new barrel style planter is available here: [https://makerworld.com/en/models/2834963-barrel-planter-springy-flower-collection](https://makerworld.com/en/models/2834963-barrel-planter-springy-flower-collection)

UPDATE: A poppy flower is now available here: [https://makerworld.com/en/models/1312871-poppy-flower-springy-flower-collection](https://makerworld.com/en/models/1312871-poppy-flower-springy-flower-collection)

UPDATE: A tulip is now available here: [https://makerworld.com/en/models/1430740-tulip-springy-flower-collection](https://makerworld.com/en/models/1430740-tulip-springy-flower-collection)

UPDATE: A sunflower is now available here: [https://makerworld.com/en/models/1694911-sunflower-springy-flower-collection](https://makerworld.com/en/models/1694911-sunflower-springy-flower-collection)