Hang your headset on this stand modeled after a vehicle piston. Great for the gamer/car enthusiast.

Printing info

You will need to print out the piston head, piston rod which is split into two pieces, 1 sleeve and 4 connectors pegs. In the print file there are multiple connector sizes. The 6mm ones worked well for me, but depending on your printer, you may need to use the ones that are slightly smaller or larger. There are two piston rod lengths. The standard one is shown it the photos, but if you have a larger headset or taller head, you may want to print out the second set which is 30mm taller.

Assembly instructions

Assembly is very easy. Insert the 4 connector pegs into one of the piston rod halves. They should be tight. Press the other piston rod half onto the pegs until the two halves touch. Insert the flat end of the assembled piston rod into the square recess of the piston head. This will also be a snug fit. Push it all the way down 'till it stops. The holes in the piston and rod should now be aligned. Insert the sleeve through the holes. And thats it! No glue required. If you need to disassemble it, just reverse the assembly steps.

If you are interested in a commercial license for this model or any of my others, please visit my Patreon page.

[https://www.patreon.com/c/JBCustomDesigns](https://www.patreon.com/c/JBCustomDesigns)