These are din rail breadboard mounts for 400 and 830 points breadboards. The
din rail clips can be attached temporarily to the breadboard base using a
piece of 1.75 mm filament. The clips can be attached horizontally or
vertically to the breadboard base. They can also be glued to the breadboard
base for a permanent setup. Clips shall be printed on their side. The 830
points Breadboard base needs two clips.

Support material is not required. An infill of 20% is recommended.

This object main web page is:
[http://www.ctheroux.com/din-rail-breadboard-mounts/.](http://www.ctheroux.com/din-rail-breadboard-mounts/.)

This object was designed using Solid Edge Community Edition.

You can request the source files on the page listed above.