Use this adapter to mount your solar panel above the roof edge line and maximize the time you panel will receive solar energy. This adapter mount helps minimize the shadow casted by the roof on the panel.

The adapter arm is fully adjustable to any angle (up to 180 degrees) to be able to best position the panel.

Printed with white PETG, it will hold up well to the elements and discoloration will not be an issue.

You can use the screws provided with the solar panel to mount the adapter to the side of the roof.

You will need four (4) sets of:

size #10 - 1" long screws with their respective washers and nuts

or

size 5mm - 25mm long screw with their respective washers and nuts

Pre-install the screws and nuts before installing the adapter to the side of the roof. Do not tighten all the way. Adjust the angle that best suits the panel. Then tighten the screws to fix the adapter angle. Install your ring adapter using the screws, washers and nuts.