Here is my desk lamp/bedside lamp.

To assemble it, you only need the 001 kit from Bambulab.

This lamp is very easy to assemble and print. The result with the fuzzy skin finish adds a lot of charm to the lamp. The colors are matte black and matte white from Bambula for this design. Additionally, it is designed to be printed on the A1mini.

For assembly, you will need:

• to print the 3 parts of my file in the color of your choice
• the 001 kit ( with the lamp and the two screws)

• a screwdriver

  

Step 1:

• Place the middle support on the base, aligning the three screw holes as you prefer, making sure they match the holes on the base, as shown in the photo, and then screw in the 2 screws that are provided with the kit

• 

Step 2:

• Then place the lamp, it should fit slightly into its base. Be careful to put the cable in the location provided for this purpose so that it fits properly. (as in the photos)

Step 3:

• Place the diffuser onto the rods; it should fit together nicely.

  If it gets stuck due to the fuzzy skin, you can trim any plastic pieces that obstruct it.

And there you go, your lamp is ready!