Spooky meets cute in this lightbox featuring a ghost and their little kitkat pal :)

Assuming I saved it right (ya never know) it should open with all the print settings already but, just in case, here's my recommendations...

Faceplate-

0.2 Layer height and update layer width to 0.35

3 walls and 10% Gyroid infill

Outer brim only with brim object gap at 0.2

Base-

0.2 layer height

3 walls and 10% Gyroid infill

Enable support (this is for the inner ledge unless you wanna trim all the strings) and I prefer tree auto, organic style, threshold 30

Outer brim only with brim object gap at 0.2

Pro tip: Don't use black in lieu of the white. I haven't tested other colors but, the black was too dense, and the light couldn't be seen through it even when I added aluminum tape.

For lighting, I used a 3ft LED light strip from Amazon and just taped it inside the base.

Definitely let me know if you encounter any issues and otherwise, happy printing!

I also took the leap and started my own Patreon for commercial use if you wanna take a peek patreon.com/JDreadfulDesigns