Minecraft Pickaxe wall hanger lamp (I was inspired by MaKim, who did sword lamp (amazing work!)

Lamp is 60 cm tall, printed in few parts.

In addition to the filament, you need an LED strip - Unfortunately, I used the cheapest one and the glue doesn't stick very well, so I had to use some hot glue. (You can use a super glue too)

Filament that i used:

• Sunlu black PLA
• Sunlu brown (coffe) PLA
• Sunlu white PLA

List of printed parts:

1-5 : Main parts

6: Pegs for connection main parts

7: Covers for LED strips in back side

8: Small pixels - 2x - One fits into the hole at the bottom, the other into the hole at the top

9: Pixels for handle 8x - differs from the others because they have a thicker base to allow less light to pass through

10: Pixels for top 16x - there are two types, higher and lower, you need 16 of them in total, so you can print however you like. I chose 12 high and 4 low

11. Wall hanger mount - two screws attached to the wall, the pick slides into place

Assembly :

1. Insert the pins in the right places, if there is too much space, you can scale the model or add glue.

2 Once the pins are in place, connect all the main pieces together

3. The beginning of the LED strip is inserted from the back to the front, we drag it to the very top and then we put it back to the back.

4. After turning the model, we guide the LED strip according to the guide and then move the strip to the front.

5. We turn again and continue gluing the lamps according to the guide from left to right and transfer them to the other side

6. We pull the LED strip to the very end, at the bend, if the glue in the tape is not very good, it is a good idea to use some hot glue.

7. Now we can put the covers on the tape

8. The last element. Insert the pixels into the holes, as I mentioned earlier, you can insert the pixels in the upper part as you like

After mounting on the wall, the whole thing looks like this