Dolphin Mandala Simple Earrings.

These are a super simple and easy file-an excellent choice to create something from those slim pickins spools (getting ready to run out or just not enough to use for major prints)

The 3MF has two different design sets-one is simple star-like/outline and the other is a Mandala Design This piece can be successfully sized up -depending on your need.. Can also be used to create a pendant to make an earring and pendant set.

Current size can use a 6-8mm/20-18 gauge jump ring for attaching

Print Time for color pattern - about 28 min

P1P/ Bambu Basic 
Aux fan should be at or below 20% or turned OFF (if using one)

Settings 
First Layer .16mm
Other layers .16mm
Ironing is turned on for top surfaces
Classic walls
2 wall loops
6 top shell
6 bottom shell 
25% Gyroid infill
Infill/wall overlap 20%
Initial Layer 35mm
Initial Layer Infill 90mm
overhang speeds 50/20/5/5

Prime tower enabled (suggest it be used on the pattern multi colored print)
Brim/Bed Adhesion: None Needed
Flushing set at default (you will need to adjust this for your filaments and machine type)