Geometric wall hooks, wide enough to hold your coats and bags, with a low profile.

All hooks protrude 3cm from the wall at their thickest part. The circular hook has a diameter of 9cm.

One or two screws are needed to hang the wall piece, the shapes are later interchangeable.

*** This model is intended for personal use only, Commercial use is not permitted ***

Printing Directions

1. Place the hook vertically on the build plate (90° from STL file).

2. Add a cube shaped modifier around the connection to the wall piece and set infill to 100%.

3. Rotate the entire print by 5°. This will help with removing supports and make layer lines less visible from the front.

4. Set infill of the general design to 10%, I like cubic but feel free to use any pattern.

5. Add supports with the following settings: Normal supports; 0.2mm Bottom z distance; 0.2mm top interface spacing; On build plate only.

6. For increasing print quality and decreasing print time, add variable layer height. Near the top (and anywhere with flatter slopes), make the layers thinner and around the center of the design make them thicker. Avoid editing the bottom of the design as this may not play nicely with the supports.

7. Set the seam to the back of the object

8. For the wall piece, place the wider side on the build plate and choose 100% infill. If printing one of the rod or ‘blob 2’ shapes, use the stl object named ‘Wallpiece - rounded’. Otherwise, either will work.

9. Add organic supports. You may need to increase the distance from the object for the support raft not to fuse with the print.

All done. Happy slicing! :)