Hello!

Another one of my passthrough designs :)

This one is Halloween themed for the contest!

It's a perfect gift for children while trick or treating and an interesting conversation starter while for halloween!

You can chose from the 2 provided versions, each are modeled after real life candy corn.

This model is print in place, you don't need to separate the inner parts!

No AMS is needed for printing!

I added a profile with pauses in the gcode so you can manually switch the filament out. Remember colors are yellow orange then white!

Also while switching filament like this make sure you clear off any exces filament that might be found on the nozzle, it can obstuct the inner “passthrough” part.

PLEASE NOTE:

I recommend printing witht OUTER brim only, after which you need to do some post processing and trim filament from between the gaps.

You can try printing them WITHOUT brims to avoid this, but this might increase the instability of the model and lead to a failed print.

Please take this into consideration while printing!

Print settings:

• 0.2mm layer height
• 2 walls
• 15% infill
• Yellow, Orange and White PLA to achieve the original look