Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
I know there are a lot of nice bag clips here already, but I wasn't entirely happy with any of them, so I added another design. There are 6 sizes for clamping lengths of 55 mm, 65 mm, 75 mm, 90 mm, 120 mm and 150 mm.
My design goals were:
- stability,
- longevity,
- high holding power,
- easy operation,
- no notoriously weak hinges,
- easy printing,
- and last but not least a pleasant appearance.
How to use:
As a rule, it is enough to bend the clip on the closure by a maximum of 1 cm in order to slide a bag between them or to remove a bag. It is not intended to bend the clip to larger angles. Bending too hard can cause the clip to break.
To open a locked clip, please use one of the two methods shown here:
Print settings:
A flexible material must be used, such as PETG. I haven't even tried printing clips with PLA since I don't think they will work for long (PLA permanently deforms under tension).
