Project: Beru.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.24mm

The Model is 139.26x180mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 3mm and the Actual Depth is 2.6mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA Sunlu Purple Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 3 unique filaments

Swap Instructions:
Start with Black
At layer #8 (0.8mm) swap to Purple
At layer #14 (1.28mm) swap to Jade White for the rest.

***I used Bambu Purple and it came out the way in my picture. I haven't calculated the TD value for this color yet, but most purple filaments should give the same effect***