I needed a camera mount which attached to a corner to allow for over 270 degrees of coverage, as well as the ability to raise or lower it from the mounting point for a better viewing angle or to avoid an obstruction.

This was printed in ABS but ASA is another option for outside use. PETG is possible but I would avoid direct midday sun if it's black.

You may notice that my print is slightly modified for my particular use, but I have left the Reolink Trackmix mounting points from the original model on this design. If you require a different width or screw hole placement or size please let me know and I can modify it for you.

51.2mm wide center on center

24.1mm high center on center

5.0mm hole diameter for a 3/16" stainless bolt or #8 screws

If you like this model please BOOST, LIKE, SHARE and RATE to show your support!