Lighter Uzi for Bic EZ Reach Lighters

With this mod you can give your normal Bic lighters a unique and fun twist.

You will need 6x 3x12mm screws to build it.
The ones I used are linked below.

One of the screws is used for the trigger mechanism and needs to be shortened to about 7mm.

Insert the pin, trigger mechanism and lighter

into one of the case halves and close it up.

Finally, screw the two halves together.

The supplied print profile is set to print by object. This means that you only have to load your wanted filament in the AMS and assign it in the slicer, both colors will be printed on one build plate.
Otherwise, you can switch back to print by layer printing.

Check out the other Lighter/Clipper builds I made!