Check out this fun magnetic fidget slider inspired by the Thwomp from Mario! This design features the Thwomp's classic expressions: awake and angry on one side, and peacefully asleep on the other. The smooth magnetic sliding action makes it satisfying to use and perfect for stress relief or keeping your hands busy.

This design is actually quite large at 76mm tall by 66.5mm wide so keep that in mind if you decide to print this.

- No superglue necessary! -

The magnet holes have a depth of 3.5mm, 6x3mm magnets might work but I have not tested as I ran out of them.

Materials needed:

• 48 * 6x2mm neodymium magnets (I used these 6x2mm magnets from amazon which are actually 6x1.75mm).

Instructions:

• The print profile will automatically pause at layer 23 (1 hour 7 minutes into the print).
• After the print is paused, carefully insert two magnets into each hole and press all the way in (Keep the magnets' polarity in mind for each half!)
• Resume the print.
• Enjoy!

After experimenting, I've found that Hilbert Curve has the best feel and finish for the top layers.

Disclaimer: 

I am not affiliated with, endorsed by, or associated with any companies or entities that own the intellectual properties that inspire my 3D models. These models are fan-made creations intended for non-commercial, personal use only. All trademarks, copyrights, and characters remain the property of their respective owners.