Gridfinity organizers for resistors or other small parts.

One bin is about 15 mm wide and 64–80 mm Long (range due to label tab).

There is a higher and lower version depending on how much you want to store.

This is a remix and is 100% compatible with normal gridfinity but I have replaced the base from the original to remove the magnet fixing base and convert it for gridfinity with pin by adding the base from that as that system requires no magnets.

This gives you more flexibility and when clicked into a base this is very solid.

If you want to use this option the gridfinity with pin bases are here:

[https://makerworld.com/en/models/440624#profileId-346300](https://makerworld.com/en/models/440624#profileId-346300)

And the original designer One Maker Show has been putting together a nice collection of gridfinity designs which are also compatible with this system which is here:

[https://makerworld.com/en/collections/1143270](https://makerworld.com/en/collections/1143270)

And a link to his show, some interesting stuff to check out

[https://www.instagram.com/mattia.confalonieri/](https://www.instagram.com/mattia.confalonieri/)

Print Instructions

• Filament : PLA works really well I've not found a need for stronger, but you could use anything
• Infill: As per profile works great but you can easily reduce it by a few percent as nothing is under stress with this
• Drying: Always well worth drying your filament whatever it is, you will get better results with dry filament!