Update 16/12/2023 - 1x1 Lid Prototype added to print profiles by request. STLs added.

-------

I designed these lids to help carry fasteners and small objects around. I think they make great little gift boxes to make Gridfinity converts!

Status: Beta

Compatibility

• Designed for 1.2mm wall divider bins
  • 
• However, mainline bins were considered and should be compatible (it would be good if someone could test it and report back!)
  • 

Print Settings

• PETG recommended for durability and ease-of-use (this is designed for PETG)
• If you have PLA with good layer adhesion, that may work for you
• Transparent PETG can show you what's inside somwhat - use a smooth plate and turn ironing on. Print slow with flowrate capped to 8mm3/s or lower, and increase the flow ratio from the default 0.95 to perhaps 0.99 to reduce the air bubbles inside.

Sizes

• More to be added as I need them but please feel free to remix your own sizes!

Check out this collection for my other Honeycomb Storage Wall models and

check out this collection for my Gridfinity models.