Project: Snake.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 169.6x240mm in size
You may print at higher layer heights below the Min Depth of 0.8mm
The Max Depth is 3.2mm and the Actual Depth is 2.5mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Gray
At layer #19 (1.6mm) swap to Beige
At layer #25 (2.08mm) swap to Jade White for the rest.