This is a Challenge Coin Holder I made for my girlfriend that could be used for other types of coins/chips, like sobriety chips, poker chips, edc coins, medals or any other item that would fit in the 5mm slots. The holder has been split into pieces so they can be painted easier. So you can do the traditional flag like I did in the preview or any color combination you'd like. I went ahead and uploaded some of the other color combinations as well. I haven't done any tuning to the print profile FYI, all settings are 100% stock and used Bambu Basic PLA.

I also made little feet to raise the back end up a little bit so there is a slight angle to the holder. They are 10mm, 15mm, 20mm. I used three on hers and worked out great.

*Note* there is a top and bottom on the feet! The top has a slight slant to it so they can be glued flat and sit flat on your deck/table/shelf!

AMS Color Slots for the 3MFs I uploaded, that way you don't have to recolor any of them.

Slot 1 / Slot 2 / Slot 3

• Traditional Color -- Red / Blue / White
• Black & Grey -- Black / Grey
• Thin Blue Line (Law Enforcement) -- Black / White / Blue
• Thin Gold Line (Dispatchers) -- Black / White / Gold
• Thin Green Line (Federal Agents, Game Wardens, Park Rangers, Border Patrol) -- Black / White / Green
• Thin Silver Line (Corrections Officers) -- Black / White / Silver
• Thin Red Line (Fire Fighters) -- Black / White / Red
• Thin White Line (Emergency Medical) -- Black / Blue / White