Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 4.6mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Green Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Blue Gray Transmission Distance: 3
This print uses 4 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Green
At layer #19 (1.6mm) swap to Jade White
At layer #31 (2.56mm) swap to Black
At layer #37 (3.04mm) swap to Blue Gray
At layer #44 (3.6mm) swap to Jade White for the rest.
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta