Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x200mm in size. You can change X and Y but Z must remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 4.6mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Jade White Transmission Distance: 5
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Silver Transmission Distance: 0.5
This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:
Start with Black
At layer #16 (1.36mm) swap to Jade White
At layer #19 (1.6mm) swap to Blue Gray
At layer #23 (1.92mm) swap to Black
At layer #32 (2.64mm) swap to Blue Gray
At layer #38 (3.12mm) swap to Jade White
At layer #45 (3.68mm) swap to Silver
At layer #48 (3.92mm) swap to Jade White for the rest.