***Notice, This print requires a .2mm nozzle and 0.02mm layer heights, it will take 48 hours to print***

Print at 100% infill with a layer height of 0.02mm with a base layer of 0.16mm

The Model is 200x200mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 1.5mm

Filaments Used:
    PLA+ Numakers Pitch Black Transmission Distance: 0.8
    PLA+ Numakers Dark Grey Transmission Distance: 4.8
    PLA+ Numakers Light Gray Transmission Distance: 3.2
    PLA+ Numakers Pure White Transmission Distance: 4.8
    PLA+ Numakers Nuclear Red Transmission Distance: 2.8
    PLA+ Numakers Fluorescent Orange Transmission Distance: 11
    PLA+ Numakers Lemon Yellow Transmission Distance: 11
This print uses 7 unique filaments

Swap Instructions:
    Start with Pitch Black
    At layer #20 (0.54mm) swap to Dark Grey
    At layer #22 (0.58mm) swap to Light Gray
    At layer #24 (0.62mm) swap to Pure White
    At layer #26 (0.66mm) swap to Nuclear Red
    At layer #33 (0.8mm) swap to Fluorescent Orange
    At layer #37 (0.88mm) swap to Lemon Yellow
    At layer #48 (1.1mm) swap to Pure White for the rest.