3D Model of the level 1 Team Fortress 2 sentry turret.

This model is completely moveable and posable so its kind of floppy, if you wish for it to stay in place I recommend you to just try and glue some parts into place. 

All parts should be sized the way they should be if you want to resize it make sure you resize all plates at once or else it may not come out right. 

I apologize if its a bit frustrating to put together I tried my best to make sure this model is as moveable and realistic looking as it can, and if you want to make it smaller do not make it too small or it might be even harder to put together.

I also recommend using a .02mm nozzle on the smaller parts so its easier for them to fit in place with other parts.

Some glue is required on some parts but most parts should be able to fit into place.

Instructions below (areas highlighted in grey are spots that should be glued)

(Make sure to glue the barrel, the light, and the grey part on top)