These fun little throwing stars are easy to throw, and almost always stick into your target with good form! They also make a great prop with their aggressive design!

Print Settings

To get maximum strength and penetration with your stars, I recommend using PETG or any other strong polymer with these settings---\/

Layer Height-- 0.1 mm

Wall Line Count-- 6

Infill Pattern-- Gyroid

Infill Density-- 60%

Supports-- No

Brim-- No

Target

I recommend using soft, porous cardboard, OR stronger cardboard that is moist or wet. These will be the most forgiving targets, and the most fun. If your Ninja Stars are not sticking, try a new target or get yours to soften up with water. Be patient and try a few different targets before you choose one to use. There is an abundance of different bullseyes online, so just print one out and stick it on your box!

Throwing

To throw your stars, pinch one of the spikes and flick it hard at your target. Always keep the Ninja Star straight up and down and try to get a good spin on it. With a max range of around 20ft, you can really get fancy with your throws!

CAUTION: ALWAYS THROW IN A SAFE DIRECTION AND NEVER AT OTHER PEOPLE OR PETS. BE AWARE OF WHAT IS IN FRONT OF YOUR TARGET AND WHAT IS BEHIND YOUR TARGET.