file:                      support:           print pitch:
partition             not req.            Rec. below 0.1mm
box                      not req.            Rec. below 0.1mm
latch                    not req.            Rec. below 0.1mm
lid                        required           Rec. below 0.1mm

Assembly: 
M2 x30mm Pan Head Small Screw x2
2x28mm Parallel Pin x2

1. Screw the pan head small screw into the case so that the outside is the head

2. Take one parallel pin, insert it into the groove of the box part from below, and push it up until you hear a "click". This will fix the pin

3. Insert the other parallel pin into the hole of the latch part and push it into the hole of the lid part. Also insert it until you hear a "click"

Dimensions with case: 
Case H: 60mm
Case W: 205mm
Case D: 190mm