My most complex model yet, interior and all, 50cm long, 30cm wide, 20 cm tall, its big and complex print , anyone need help i am here as always to answer any questions and help anyway i can.

This is an exploration vehicle part of a trio i am doing with a space exploration theme.

UPDATE 1: 19.08.2024 - Added the bill of materials from bambu lab, made the instructions a little more specific , also i didnt mention before but i tried to use as little glue as possible , so only on the canopy assembly and the name plates glue is used 

UPDATE 2: 21.08.2024 - a component mismatch was spoted on plate 22 and i am truly sorry for the people who wasted filament and time on that plate, all is rechecked and ok now

UPDATE 3: 24.08.2024 - stupid that i am and in a hurry i never bothered to check the actual with of the screws i used being bought in bulk sets. truly sorry for this to everyone who actually bought them in advance - I UPDATED the BOM and the assembly guide - there is really no excuse for this, so sorry again

Materials used:

BAMBU LAB PLA MATTE CHARCOAL

BAMBU LAB PLA MATTE LEMON YELLOW

BAMBU LAB PLA MATTE IVORY WHITE

BAMBU LAB PLA MATTE ASH GREY

BAMBU LAB PLA SPARKLE SLATE GREY

6x M4 NUTS

46x M4X10 - SCREW

10x M4X16 - SCREW

24x M4X25 - SCREW

2x M4X120 - SCREW

2x M4X6 - HEADLESS SCREW