Problem

I wanted a simple project box that will work for most projects with an ESP32/ESP8266 board.  I'm mounting the sensors with some mounting tape and don't want to spend a lot of time messing around with screws and measuring.  There are lots of very well done, low tolerance project boxes out there that need customization and specific board versions, I needed one that would just work.

Solution

This box has 5-10mm of slop on either side, or lets call it margin.  The lid clips on nicely and the mesh has enough gaps to pass some wires through.  For closet and garage monitoring this is chic. 

Printing

Prints without supports, When inserting lid for first time, ease it in from an angle and friction will hold it together. A like is appreciated if you use this. ❤