Boston & Maine Railroad “The Rye Beach” clock. This image is from the drumhead that was used on the “The Rye Beach” passenger train.

This clock is approximately 230mm in diameter. Almost any clock mechanism should work as long as the threaded shaft is 8-10mm long at a minimum and less then 60mm square.

This profile worked fine for me on my X1C, but you may find some profile settings that will work better for you.

If you like railroad coasters, take a look at my other railroad coasters and clocks at  [https://makerworld.com/en/@railimages](https://makerworld.com/en/@railimages)

I would appreciate it if you could rate my print profile and maybe even give it a BOOST, Thanks and enjoy!