Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The Model is 200x200mm in size. You can change the X and Y but Z can remain the same.
You may print at higher layer heights below the Min Depth of 0.48mm
Actual Depth is 4.5mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.3
PLA BambuLab Basic Blue Gray Transmission Distance: 3
PLA BambuLab Basic Red Transmission Distance: 5.5
PLA BambuLab Basic Beige Transmission Distance: 8
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments. Substitute as needed.
Swap Instructions:
Start with Black
At layer #17 (1.44mm) swap to Blue Gray
At layer #21 (1.76mm) swap to Red
At layer #27 (2.24mm) swap to Black
At layer #31 (2.56mm) swap to Beige
At layer #45 (3.68mm) swap to Jade White for the rest.
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta