Stackable Fruit Basket / Strawberry Carton

My girlfriend challenged me to design a Strawberry Carton that resembles its real-life cardboard counterpart; Introducing the 3D Printed Strawberry Carton! This was a lot of fun to create and I hope you can get some use out of it :)

I used Bambu Lab PETG Translucent Pink and some Generic PLA as a wonderful support interface!

Print Settings:

Layer Height - 0.16mm High Quality

Arachne Walls

15% Gyroid Infill

Slow Speeds (20-120mm/s)

Prime Tower: Optional but I opted to leave it

Supports: Required due to the large overhang near the top of the model

I used Slim Tree Supports with a 35 Degree Threshold Angle

I used PLA as a support interface: HERE is a wonderful guide to using PLA as a support interface brought to you by the Bambu Community!

Descrição