These are a set of floor supports for OpenLock primary floor tiles. The supports are designed to stack if required enabling them to be combined if required.

These currently support OpenLock floor tile sizes E, R, S and U.

Each support comes in four different heights for the following purposes: -

• 1-inch - Underside of a tile will be at the top of a low wall
• 2-inch - Underside of a tile will be at the top of a full 2" wall
• 18mm - Top of the tile base is in-line with a low wall
• 37mm - Top of the tile base is in-line with a full 2" wall

The supports are compatible with the OpenLock v7.6 bases.

Note The pegs on each support may obstruct one of the end Triplex connectors on each edge, however, for most orthogonal connections between tiles this should not be an issue.

Original inspiration was taken from [https://www.thingiverse.com/thing:3020197](https://www.thingiverse.com/thing:3020197) but I needed them to work with OpenLock 7.6 and wanted full sides.