This is a magnet representing the USAF Tech Control Water Walkers challenge coin / logo. I had to redesign the logo a bit due to poor quality images elsewhere on the net.

Printed size is 75x75x3.25mm

Bottom has 2 removable supports to reveal holes for 15x15x1mm magnets. This is optional.

Originally conceived to use the image to keychain feature but that isnt workable with more than 4 colors on a single AMS, so I redid this in Hueforge.

=================================================

Project: Waterwalkers Coin Magnet.hfp
Print at 100% infill with a layer height of 0.1mm with a base layer of 0.1mm

The Model is 200x190.29mm in size
You may print at higher layer heights below the Min Depth of 2mm
The Max Depth is 3.3mm and the Actual Depth is 3.3mm

Filaments Used:
PLA PolyLite Black Transmission Distance: 0.3
PLA+ IIID Max Blue Transmission Distance: 2.8
PLA+ Ankermake Red Transmission Distance: 5.6
PLA+ IIID Max Light Blue Transmission Distance: 2.6
PLA PolyLite Pro Cold White Transmission Distance: 0.5
This print uses 5 unique filaments

Swap Instructions:
Start with Black
At layer #21 (2.1mm) swap to Blue
At layer #23 (2.3mm) swap to Red
At layer #26 (2.6mm) swap to Light Blue
At layer #29 (2.9mm) swap to Cold White for the rest.