For those of you feeling guilty about all that turtleneck meat in your inventory, you can print yourself an Elden Ring Dog HueForge as a tribute.

• There are two AMS profiles with dimension being the only difference:
  • Small: 72 x 67 x 1.68 mm / 2.8 x 2.6 x .06 in
  • Large: 163.6 x 152.4  x 1.68 mm / 6.4 x 6 x .06 in

A HueForge can take a bit to slice, but all the settings in the slicer are ready for a 0.4 nozzle. Below are the filament swap instructions. Keep in mind that if you use a different brand than I did, the color of the print might vary.

• Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
• You may print at higher layer heights below the Min Depth of 0.48mm
  The Max Depth is 2.2mm and the Actual Depth is 1.7mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Gray
At layer #11 (0.96mm) swap to Jade White for the rest.

Please share your prints in the comments, especially if you create a nice looking color variation.